[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
help
Dear Sir/Madam,
I'm a PhD student doing research in IP/ATM networking. I'd like to use
your ns2 network simulator for my work. I just download all the
software as you instructed on
http://www-mash.cs.berkeley.edu/ns/ns-build.html And then Building it
>From Sources
Fetch the source code as described above.
Unpack TclCL and ns source into the same top level directory.
Build TclCL:
cd into the ``TclCL directory'' (inappropriately called ``Tcl'';
we will fix this...)
run ./configure
run make
Build ns:
cd into the ns directory
run ./configure
run make
But I can't run configure. The message is as follows:
banyan{dpwu}117>ls
Tcl-1.0b2 ns-2.0b17
banyan{dpwu}118>cd Tcl-1.0b2
/home/kings/u1/dpwu/NS-2/ns/Tcl-1.0b2
banyan{dpwu}119>ls
CHANGES.html config.sub tcl-object.tcl
FILES configure tcl2c++.c
Makefile.in configure.in tclAppInit.cc
README idlecallback.cc timer.cc
Tcl.cc idlecallback.h timer.h
Tcl.h install-sh tkAppInit.cc
Tcl2.cc iohandler.cc tracedvar.cc
VERSION iohandler.h tracedvar.h
conf rate-variable.cc
config.guess rate-variable.h
banyan{dpwu}120>configure
configure: Permission denied
banyan{dpwu}121>./configure
./configure: Permission denied
Would you please help me with this?
Your help is highly appreciated.
Best regards,
Dapeng
--
*********************************************************************
Mr. Dapeng Wu
Center for Advanced Technology Tel:(718) 260-3496 or
in Telecommunications (CATT) 260-3973 (office)
Department of Electrical Engineering (718) 834-9851 (home)
Polytechnic University Fax:(718) 260-3906
6 MetroTech Center
Brooklyn, NY 11201 Email: [email protected]
*********************************************************************